COMPETENCE 1 – Maintain a Safe Engineering Watch
Results
Congratulations! Share the result.
Try again. There is always a chance. Review the results.
#1. When the load is increased on a turbocharged diesel engine, the amount of increased air supplied by the turbocharger will:
Incorrect!
#2. What is the speed of the crankshaft in a four stroke/cycle engine when the camshaft is turning at 750 rpm?
Incorrect!
#3. The safety valve installed on a coil- type auxiliary boiler is located on the.
Incorrect!
#4. With an increase in temperature the volume of flammable and combustible liquids:
Incorrect!
#5. Thin bronze rings are inserted in the face of some chromium plated piston rings to:
Incorrect!
#6. The possibility of a flareback in a boiler will be reduced if you:
Incorrect!
#7. The watch engineer finds the cargo refrigeration compressor has blown the shaft seal, with the noticeable presence of oil leaking. In this situation, what should be done?
Incorrect!
#8. Using a diesel engine indicator P-V diagram, the cylinder mean effective pressure is calculated to be 21.3 kg/cm2. What is the scale of the spring used on the indicator if the diagram area is 18.46 cm2 with a length of 13 cm?
Incorrect!
#9. The ratio of the brake horsepower to the indicated horsepower of a diesel engine is its:
Incorrect!
#10. The vapor pressure of a gas is the pressure necessary to keep it in a(n):
Incorrect!
#11. Which of the events listed does NOT occur during the instant the piston just reaches top dead center?
Incorrect!
#12. The total air capacity for non- reversible main engines is to be sufficient for:
Incorrect!
#13. What is the equivalent tonnage of a refrigeration system rated at 48,000 BTU per hour?2.5
Incorrect!
#14. When an additional load is applied to a diesel engine which is using an inadequately inflated air bladder clutch unit, you can expect:
Incorrect!
#15. Which of the following ring designs is commonly used on new piston rings to facilitate run-in or seating?
Incorrect!
#16. Which of the following fuel oil characteristics establishes the danger point when transferring, pumping, and firing procedures are concerned?
Incorrect!
#17. Turbulence is created in the cylinders of a diesel engine to:
Incorrect!
There are 14 questions for the actual examination for Competence 1 for OIC-EW with a passing rate of 70%. This means that you are only allowed to make 4 mistakes.
DISCLAIMER
The questionnaires contained in this “reviewer” are extracted from the post released by MARINA on their official website and other review materials. Please note that Seaman Kowts is not affiliated with, endorsed by, or connected to the official website of MARINA. The information provided on this website is for general informational and educational purposes only and should not be relied upon as official or authoritative. If you require official information or services, please visit the official website or any relevant review center. We do not assume any responsibility or liability for any consequences resulting from the use of information or services provided on this website.
