OIC-EW MARINA REVIEWER / QUIZ COMPETENCE 4 - PART 3 - Seaman Kowts

COMPETENCE 4 -Operate Main and Auxiliary Machinery and – Associated Control Systems

Results

Congratulations! Share the result.

Try again. There is always a chance. Review the results.

#1. Air compressor cylinder unloader enable the compressor to __________.

vary their speed according to temperature and load

change speed according to overload demands

reduce compressed air charge density

start and come up to speed before air compression begins

Incorrect!

#2. Breaking the fuel into fine spray to provide good combustion is called ______.

refining

purifying

honing

atomizing

Incorrect!

#3. Which of the following descriptions best identifies the operating principle of a flash-type evaporator?

Sea water is heated to boiling temperature while under a vacuum.

Sea water is passed over heated plates in a thin film.

Sea water is forced through a heated eductor

Heated sea water is injected into a vacuum chamber

Incorrect!

#4. In a refrigeration system, the amount of superheat absorbed by the refrigerant is adjusted at the _______.

condenser

expansion valve

evaporator

compressor

Incorrect!

#5. In a low pressure air compressor, the loss of volumetric efficiency normally results from _______.

heating of the air leaving the cylinders

adiabatic compression in the intercooler

inaccurate valve timing

constant enlargement of the clearance expansion volume

Incorrect!

#6. A squeaking sound occurring from within an operating reciprocating air compressor is an indication of ______.

tight compressor bearings

compressor overload

motor overload

badly leaking unloaders

Incorrect!

#7. Boiler fire side must be kept free of soot accumulations because ________.

soot interferes with the flow of feedwater

the steam drum internals will become clogged

the fuel oil heaters will become overloaded

soot insulates the boiler heating surfaces

Incorrect!

#8. Kinetic energy is associated with ________.

heat

movement and relative velocity

degree of atomic and molecular motion

relative position in respect to datum reference level

Incorrect!

#9. The thermostatic expansion valve of a refrigeration system is opened _________.

by refrigerant pressure and close by spring pressure

by spring pressure and close by refrigerant pressure

and close by spring pressure

and close by refrigerant pressure

Incorrect!

#10. The expansion tank for the jacket cooling water which is a closed cooling type is used to _______.

maintain constant head in a system

allow easy release of air

prevent water leakage

reduce air contamination

Incorrect!

#11. Main engine lube oil sump tank is located ______.

above the engine

at the same level as the main bearing

at the bottom of the engine

next to the engine

Incorrect!

#12. A dehydrator installed in a refrigeration system is used to remove _______.

oil from the refrigerant

refrigerant from the oil

moisture from the system

non-condensable gases and vapors

Incorrect!

#13. Salinity cell is installed in the distilling unit to indicate the _______.

quantity of freshwater produced

leaking tube

amount of chemical to be added

quality of water produced

Incorrect!

#14. If an air compressor intercooler pressure rises above normal, it usually indicates _______.

dirty lube oil

dirty intercooler

hot environment

leaking valves

Incorrect!

#15. Refrigerant is circulated through a refrigeration system by the __________.

condenser

compressor

expansion valve

evaporator

Incorrect!

#16. The Brayton Cycle is one where the combustion event occurs at _________.

constant temperature

increasing pressure

constant pressure

All of the options

Incorrect!

#17. The "general energy equation" expresses energy in which of the following forms?

thermal

potential

kinetic

All of the options

Incorrect!

#18. Fuel oil enters the main engine cylinder through _________.

plunger and barrel

starting valve

fuel oil injector

oil spill valve

Incorrect!

#19. The inlet pipe connection of dirty oil in disc type centrifugal purifier is located at the________.

top of the bowl cover

bottom of the bowl cover

top and bottom of bowl cover

side of the bowl cover

Incorrect!

#20. A mooring winch should be equipped with mechanical brakes capable of holding______.

50% over the working tension of the mooring line

the full breaking strength of the mooring line

half the breaking strength of the mooring line

the maximum expected tension of the mooring line

Incorrect!

#21. The degree of fuel atomization in a diesel engine cylinder depends primarily on _________.

timing of the pump

supply pressure to the pump

shape of the combustion chamber

the size of the holes in the fuel nozzle

Incorrect!

#22. Boyle's law can best be defined as _______.

the volume of an enclosed gas varies inversely with the applied pressure, provided the temperature remains constant

if the pressure is constant, the volume of an enclosed gas varies indirectly with absolute temperature

a body at rest tends to remain at rest.

None of the stated options

Incorrect!

#23. Fluctuations in the pressure and temperature of the steam supplied to the first-effect of a low pressure submerged tube distilling plant will cause ________.

first effect scale formation to be loosened

pressure and temperature fluctuations in the entire unit

increased heat levels throughout the entire unit

decreased priming and lower salinity distillate

Incorrect!

#24. Salinity cell is installed in the distilling unit to indicate the ________.

quantity of freshwater produced

leaking tube

amount of chemical to be added

quality of water produced

Incorrect!

#25. The purpose of expansion valve is to __________.

provide an orifice between the high pressure and low pressure side of the system

change the gas to a liquid

provide a chamber for the pre- expansion of the liquid

to speed-up the flow of refrigerant

Incorrect!

#26. The liquid indicator sight glass is generally located in the _________.

high pressure vapor line

low pressure vapor line

high pressure liquid line

low pressure liquid line

Incorrect!

#27. Burned gas from each cylinder is directed to the exhaust manifold which is part of _________.

2-stroke engine

both 4-stroke engine and 2 stroke engine

4-stroke engine

internal combustion engine

Incorrect!

#28. It is a form of energy which crosses the boundary of a system during a change of state produced by a difference of temperature between the system and its surroundings.

Potential energy

first law of thermodynamics

Heat

Kinetic energy

Incorrect!

#29. A salinity indicating system functions on the basic principle of measuring the __________.

hydrogen ion concentration of water

electrical conductivity of water

electrical inductance of water

specific gravity of water

Incorrect!

#30. The purpose of the low pressure cutout switch is to _______.

maintain a preset suction pressure to the compressor

maintain liquid refrigerant at the suction of the compressor

start and stop the compressor at preset operating pressures

operate at minimum efficiency

Incorrect!

Finish

There are 30 questions for the actual examination for Competence 4 for OIC-EW with a passing rate of 70%. This means that you are only allowed to make 9 mistakes.

DISCLAIMER

The questionnaires contained in this “reviewer” are extracted from the post released by MARINA on their official website and other review materials. Please note that Seaman Kowts is not affiliated with, endorsed by, or connected to the official website of MARINA. The information provided on this website is for general informational and educational purposes only and should not be relied upon as official or authoritative. If you require official information or services, please visit the official website or any relevant review center. We do not assume any responsibility or liability for any consequences resulting from the use of information or services provided on this website.

Results

#1. Air compressor cylinder unloader enable the compressor to __________.

#2. Breaking the fuel into fine spray to provide good combustion is called ______.

#3. Which of the following descriptions best identifies the operating principle of a flash-type evaporator?

#4. In a refrigeration system, the amount of superheat absorbed by the refrigerant is adjusted at the _______.

#5. In a low pressure air compressor, the loss of volumetric efficiency normally results from _______.

#6. A squeaking sound occurring from within an operating reciprocating air compressor is an indication of ______.

#7. Boiler fire side must be kept free of soot accumulations because ________.

#8. Kinetic energy is associated with ________.

#9. The thermostatic expansion valve of a refrigeration system is opened _________.

#10. The expansion tank for the jacket cooling water which is a closed cooling type is used to _______.

#11. Main engine lube oil sump tank is located ______.

#12. A dehydrator installed in a refrigeration system is used to remove _______.

#13. Salinity cell is installed in the distilling unit to indicate the _______.

#14. If an air compressor intercooler pressure rises above normal, it usually indicates _______.

#15. Refrigerant is circulated through a refrigeration system by the __________.

#16. The Brayton Cycle is one where the combustion event occurs at _________.

#17. The "general energy equation" expresses energy in which of the following forms?

#18. Fuel oil enters the main engine cylinder through _________.

#19. The inlet pipe connection of dirty oil in disc type centrifugal purifier is located at the________.

#20. A mooring winch should be equipped with mechanical brakes capable of holding______.

#21. The degree of fuel atomization in a diesel engine cylinder depends primarily on _________.

#22. Boyle's law can best be defined as _______.

#23. Fluctuations in the pressure and temperature of the steam supplied to the first-effect of a low pressure submerged tube distilling plant will cause ________.

#24. Salinity cell is installed in the distilling unit to indicate the ________.

#25. The purpose of expansion valve is to __________.

#26. The liquid indicator sight glass is generally located in the _________.

#27. Burned gas from each cylinder is directed to the exhaust manifold which is part of _________.

#28. It is a form of energy which crosses the boundary of a system during a change of state produced by a difference of temperature between the system and its surroundings.

#29. A salinity indicating system functions on the basic principle of measuring the __________.

#30. The purpose of the low pressure cutout switch is to _______.

You may interested:

OIC-EW MARINA REVIEWER / QUIZ COMPETENCE 3 – PART 8

OIC-EW MARINA REVIEWER / QUIZ COMPETENCE 4 – PART 5

OIC-EW MARINA REVIEWER / QUIZ COMPETENCE 2 – PART 3